Concrete Sidewalks & Walkways in Johns Creek & North Fulton
Broom-finish and decorative concrete walkways, garden paths, and sidewalks that connect your driveway, porch, and yard, poured to drain right and resist the cracking Georgia clay causes.
Get Your Free Quote
Tell us about your project. We reply fast, usually same day.
Walkways Built for North Fulton Yards
A good walkway does two jobs: it looks like part of the house and it moves water away instead of trapping it. We pour walkways and sidewalks on a compacted graded-aggregate base with the right reinforcement and joint spacing so they stay flat and crack-controlled for decades.
- Standard 4-inch walkways, thickened to 6 inches where they cross a driveway or take vehicle loads
- 3,000 to 4,000 PSI mix over a compacted graded-aggregate base (GAB)
- Wire mesh or #3 rebar and correctly spaced control joints to manage cracking
- Broom, exposed-aggregate, or stamped finishes to match your home and driveway
- Slope set for positive drainage so water sheets off, not toward the house
- Clean tie-ins to your driveway, porch, steps, and existing hardscape
What does a concrete walkway cost in Atlanta?
Walkway pricing depends on the finish, the width and length, reinforcement, and whether an old walk has to come out first. These are typical Metro Atlanta ranges, and we give a firm written price after a free on-site measure.
Standard broom-finish walk
A reinforced 4-inch broom-finished walkway generally runs $8 to $15 per square foot installed over a compacted base.
Exposed aggregate
Seeded or washed exposed-aggregate walkways typically run $10 to $18 per square foot depending on the stone and finish.
Stamped & decorative
Stamped and colored walkways that match a stamped patio or driveway usually run $14 to $22 per square foot.
Tear-out & haul-away
Removing and hauling an old, cracked walk before the new pour is quoted as a clear, separate line item.
Broom vs Exposed Aggregate vs Stamped
All three ride on the same properly prepared base. The finish is about looks and budget; the base and joints are what keep any walkway from cracking.
| Finish | Best For | Slip Resistance | Typical Cost / sq ft |
|---|---|---|---|
| Broom finish | A clean, classic look that fits most homes and budgets | High, the broom texture grips when wet | $8 to $15 |
| Exposed aggregate | A natural, pebbled surface that hides dirt and wear | High, the exposed stone is naturally grippy | $10 to $18 |
| Stamped & colored | Matching a stamped patio or driveway for a high-end look | Good, we add a non-slip additive to the sealer | $14 to $22 |
On Georgia clay the base prep matters more than the finish. We compact a graded-aggregate base and cut control joints at the right spacing so the walkway cracks along the joints, not across the surface.
How We Pour Your Walkway
Measure & Layout
We measure the run, check the grade and drainage, and give you a written price.
Base & Forms
We remove the old walk if needed, compact a graded-aggregate base, and set forms to the right slope.
Reinforce & Pour
We add wire mesh or rebar, pour, and screed to grade.
Finish, Joint & Seal
We apply your chosen finish, cut clean control joints, and seal decorative surfaces.
Concrete Sidewalks & Walkways in the Atlanta Metro
Walkways, paths, and flatwork we have finished for Atlanta-area homes.
We Do It All in Concrete
One local crew for every concrete project around your home.
The CIT Workmanship Guarantee
We have built our reputation across Johns Creek and Metro Atlanta since 2011 by standing behind every pour. If something is not right with our workmanship, we make it right. In writing, on every project.